Conair MPA Informations techniques télécharger pdf (Page 4)

MPA–II v2 Fault messages

V 1.0 |–>

01T01995_0

6.4.00

The Warning messages :

* OK,PUSH START KEY * End of reset ; cycle start authorized

*Hit START to restart*

The emergency stop line has been cut. You must energize the robot again by

pressing START.

* MVts COMPLETED *

In Step by Step mode : the step change is authorized. Release the START key and

then press it down again.

* END OF CYCLE * The stop at cycle end request has been memorized.

* END OF JOBS *

The stop at cycle end has been triggered by an ’end of counting’ or an ’end of

stacking’.

* POWER ? * Power up the emergency stop circuit again

* EMERGENCY STOP * The emergency stop line has been cut.

* EJECTORS ? *

Waiting for the control input of one of the 2 ejector movements (back or forward)

to change step.

*waiting Auxil input?* Waiting for an auxiliary input to change step.

* End CORE action ? * Waiting for the control input of one of the core movements.

*machine cycle over? * Waiting for the machine to open with a finished part.

* INITIALISE X and Y * Move into adjust mode and initialize the numeric axes.

* INITIALISE X * Move into adjust mode and initialize the X axis.

* INITIALISE Y * Move into adjust mode and initialize the Y axis.

1 2 3 4 5 6 7 8 9 ... 16 17

Pas de commentaire

Modely	Typ Dokumentu
Bitspeek RE	Uživatelský manuál Sonic Charge Bitspeek RE User Manual, 12 stránky
Permut8	Uživatelský manuál Sonic Charge Permut8 User Manual, 14 stránky

Conair MPA Informations techniques Page 4