Conair MPW Spécifications télécharger pdf (Page 69)

OUTPUT TEST

Thermolator TW-1 and TW-2 UGH015/0100

5-8 MAINTENANCE

The Output Test verifies the function of outputs available on

the various TW-1 and TW-2 models. Not all outputs are used

on all models. The performance evaluation of the inputs is

based on the output monitors (OM).

Connect all outputs to the system.

Enable Test Mode.

Press any key to display the first test menus.

Select the Output Test menu.

Press and hold the Setpoint key for 3 seconds to index

to each test menu until the controller displays “oUt”.

Repeatedly press and release any key to test.

With each key press and release, the left display will indi-

cate the number of the output being tested (oS1= OM1;

oS2 = OM2; etc.). The right display indicates either “1”

for a good output or “O” for a failed output.

Only outputs that are actually used by the particular model

will be tested.

Exit the test and enter the next test.

Press and hold the Setpoint key for 3 seconds to exit

and index to the next test.

IMPORTANT: Testing each output requires the fir-

ing of the associated solid state relay. Make sure an

output device is connected to the controller, other-

wise the test result will be erroneous.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 118 119

Pas de commentaire

Modely	Typ Dokumentu
Bitspeek RE	Uživatelský manuál Sonic Charge Bitspeek RE User Manual, 12 stránky
Permut8	Uživatelský manuál Sonic Charge Permut8 User Manual, 14 stránky

Conair MPW Spécifications Page 69