Conair obusforme ObhP08C Manuel d'utilisateur Page 1
Naviguer en ligne ou télécharger Manuel d'utilisateur pour Masseurs Conair obusforme ObhP08C. USE AND CARE Manuel d'utilisatio
- Page / 2
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
USE AND CARE
Congratulations on your purchase of the Obus Forme
®
by Conair
®
Heat
and Massage Seat Cushion™. The Seat Cushion features heat for the lubar
area and four powerful massage mortors, with three automatic safety shut-
off devices. An ergonomically designed handheld controller is built into the
seat cushion allows you to personalize your experience with ease. The Obus
Forme
®
by Conair
®
Heat and Massage Seat Cushion™ is ideal for use in your
vehicle, at home and in the office.
For optimum performance and safety, please read these instructions carefully
before using your Backrest.
How to Secure your Obus Forme Seat Cushion to
a Vehicle Seat
1. Slide strap “A” and strap “B” over the back of your vehicle seat. Adjust the
seat cushion on your vehicle seat to your personal preference.
2. Attach strap “LC” to strap “RC”, securing with the plastic hooks located on
the end of each strap.
3. Attach strap “LD” to strap “RD”, securing with the plastic hooks located on
the end of each strap.
4. Pull strap “C” over your headrest and secure it to strap “A” using the
buckle attached.
Warning!
Use caution when stretching and securing the elastic straps. The elastic straps
may recoil and cause injury if you fail to properly secure the plastic hooks before
releasing the elastic straps.
HOW TO OPERATE THE HEAT FUNCTION
Your Obus Forme
®
by Conair
®
Ultimate Backrest has a built-in heat function (3).
1. Ensure that your Backrest is plugged into an electrical outlet.
2. To activate the heat function, press the heat on/off button (10) once, using the
handheld controller.
3. To deactivate the heat function, press the heat on/off button (10) again,
using the handheld controller. Unplugging the unit will also deactivate the
heat function.
SAFETY FEATURES
Automatic Heat Shut-Off
Your Obus Forme
®
by Conair
®
Ultimate Backrest is equipped with a built-in
thermostat to regulate the temperature of your Backrest. The heat function
will automatically shut down if the temperature gets too hot. You can safely
reactivate the heat immediately after automatic shut-off. After approximately
35 minutes of continuous use, your Backrest will reach a temperature of about
50-60°C (122–140°F). The temperature will not exceed 75°C (167°F).
Automatic Power Shut-Off
Your Obus Forme
®
by Conair
®
Ultimate Backrest is equipped with a safety
feature that will automatically turn the power off any features you may have
running after approximately 35 minutes of continuous use. This prevents
wasted electricity in case you forget to turn the power off, and also acts as a
preventive measure against potential fire hazards. You can safely reactivate the
heat and/or massage immediately after automatic shut-off. Please note that the
CustomAIR
™
lumbar support is not affected by the automatic shut-off.
How to Adjust the CustomAIR
™
Lumbar Support
The unique built-in CustomAIR
™
inflatable lumbar support system allows you
to inflate and deflate the lumbar support to suit your individual needs. Once
you have adjusted the CustomAIR
™
lumbar support to your liking, it will remain
fixed until you inflate or deflate it again. Your lumbar support will not deflate if
you unplug your Obus Forme
®
by Conair
®
Ultimate Backrest from the electrical
outlet. For best results, rest your lower back against the lumbar area before
adjusting the lumbar support.
1. Ensure that your Obus Forme
®
by Conair
®
Ultimate Backrest is plugged in.
2. To inflate the lumbar support, press the CustomAIR
™
inflate button (7).
Continue to press this button until you attain the amount of lumbar support
you find most comfortable.
3. To deflate the lumbar support, press the CustomAIR
™
deflate button (8).
SAVE THESE INSTRUCTIONS
HOW TO OPERATE THE MASSAGE FUNCTION
Your Obus Forme
®
by Conair
®
Ultimate Backrest is equipped with four massage
motors (1) that allow you to choose from either a continuous or pulse massage.
Six different massage patterns are available for each type of massage, as
shown below. Three speed settings are also available in each mode: low,
medium and high.
1. Ensure that your Backrest is plugged into an electrical outlet.
2. To activate the massage motors, press the power on/off button (11) once
using the handheld controller.
3. Select a continuous or pulse massage by pressing the pulse/massage button
(9) until your desired massage is lit (9a).
4. Select from one of six massage patterns by pressing the massage mode
button (13) until your desired massage mode number (13a) and pattern (13b)
are indicated. Massage modes 1-6 will correspond with the massage mode
patterns shown in the diagram.
5. Select from one of three speed settings by pressing the speed control button
(12) once until your desired massage is lit (12a).
6. To deactivate the massage motors, press the power on/off button (11) again,
using the handheld controller. Unplugging the unit will also deactivate the
massage motors.
FEATURES OF YOUR OBUS FORME
®
BY CONAIR
®
ULTIMATE BACKREST
Front
1. 4 Massage motors
2. "S"-shaped frame
3. Built-in heat system (heat coil)
4. Polyurethane foam
5. Inflatable lumbar support (air bladder)
6. Pocket for handheld controller
Handheld Controller*
7. CustomAIR
™
inflate button
8. CustomAIR
™
deflate button
9. Pulse/massage button
9a. Pulse/massage indicator light
10. Heat on/off button
11. Massage power on/off button
12. Speed control button
12a. Speed indicator light
13. Massage mode button
13a. Mode indicator light
13b. Mode pattern indicator
Back
14. Cable management loop with hook-and-
loop closure**
15. Electrical cord for handheld controller
16. Electrical cord for car and AC adapters
16a. Adapter attachment head
17. Car adapter plug
18. AC adapter plug
* Please note that the handheld controller has been built into the Obus Forme
®
by Conair
®
Ultimate
Backrest and cannot be detached from the unit.
** The handheld controller on the Obus Forme
®
by Conair
®
Ultimate Backrest can
easily be adjusted for left-hand use simply by releasing its electrical cord from
the hook-and-loop closure.
1
2
Résumé du contenu
Page 1 - USE AND CARE
USE AND CARECongratulations on your purchase of the Obus Forme® by Conair® Heat and Massage Seat Cushion™. The Seat Cushion features heat for the luba
Page 2 - INSTRUCTIONS
IN ST RU CT IO N B OO KL ET FO R M OD EL UB RFor your safety and continued enjoyment of this product, always read the instruction book carefully
Plus de documents pour Masseurs Conair obusforme ObhP08C
Produits connexes et manuels pour Masseurs Conair obusforme ObhP08C
(12 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.999 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels